Carrying Out Quick Dimensioning in a Two-Pipe System

Shows step-by-step how to carry out a rapid design for all rooms on a floor in a two-pipe system. The preselection options and specifications are used for the design.

Before you begin

You would like to perform a quick dimensioning of all rooms of a storey in the two-pipe system.

Requirements:

  • You have already added a radiator or cooling convector to the preselection.

  • In the Radiator preselection or Cooling convector preselection dialog, you have selected a Two-pipe system as the system.

Note:

For a correct dimensioning of radiators or cooling convectors, a broad assumption of the heat or cooling load is unsuitable; a comprehensive calculation of the heat or cooling load is required.

Navigate to:

Module overview ➤ Radiators/Cooling convectors ➤ Storey level ➤ Radiators/Cooling convectors ➤ Storey overview and quick dimensioning

Procedure

  1. If necessary, in the Manufacturer and model series section, select the desired model series you want to dimension for the rooms of the selected floor.
  2. Adjust the Dimensioning options if necessary.
  3. Remove the check mark in the B column for the rooms that should not be dimensioned.
  4. Click Dimensioning in the toolbar.
    Note:

    If you would like to design industrial heating or cooling elements, such as ceiling panels or radiant ceiling profiles, an interim dialog with further dimensioning options will appear before the design.

Results

LINEAR Building has designed all rooms to be laid out with radiators or cooling convectors.

What to do next

In the next step, you can rework in detail the radiators or cooling convectors that were not optimally designed.