Re-sorting Manifold Connections

Shows step by step how you can re-sort manifold connections.

Before you begin

You would like to change the order of the feed pipes at the manifold before drawing in the circles.

In this example, the first two manifold connections are assigned to the two circuits of the living room. In order to move one or more lines around a single manifold connection or move them to the end of the table, use the other buttons of the Connection sequence section.

Requirement:

Your project includes several circuits.

Navigate to:

Module overview ➤ Module selection ➤ Pipe run view ➤ Heating manifold

Applies to: Radiators, cooling convectors, panel heating, panel cooling.

Procedure

  1. Mark the desired lines with the left mouse button held down.

  2. Click .

Results

Both circuits are assigned to the first two connections.