-
In the Property Sets area, click
Create Property Set, enter the Name for the property set in the Property Set dialog that appears, and click OK.The property set is created, added to the list of Property Sets, and selected for editing.
-
In the Display in Following Structures area, select the structure configurations in which the room data sheet view of the property set is to be displayed.
-
In the Available parameters area, select the desired parameters to add them one after the other to the Selected Parameters list using the
button. -
In the Selected Parameters area, check the units of the parameters and adjust the settings if necessary using the
buttons in the fields of the Unit column. -
In the Aggregation column, use the
buttons to specify whether and with what type of aggregation the values of the associated rooms should be displayed aggregated at the levels of the structural elements (e.g., building section or floor). -
Use the
buttons in the Restrictions column to define conditions for the value ranges of the parameters. -
Use the
buttons in the Calculation column to define calculation formulas with references to other parameters and/or variables for the values of the parameters. -
If necessary, use the buttons
Move Parameter Forward and 
Move Parameter Back to adjust the order of the parameters so that the columns of the parameters are displayed in this order in the room data sheet view of the property set. -
Click Close.
The property set is created and displayed in the selected structure configurations in the room data sheet view.