Details on Technical Data for Differential Pressure Transducer
Information about the technical data dialog for Differential pressure transducer.
Similar to the differential pressure controller, there is also a technical data dialog for differential pressure transducers. In this dialog, you specify the component data that will be used in the calculation. Here, you can also select a valve from the valve selection dialog specifically for this component. In addition, for manufacturer-neutral fittings, you can select the connection type for the component connections.
You are here:
Name
In this field you can enter an individual name for the component. Clicking on 
restores the original name and overwrites the previous entry.
Valve Data
Select… Opens the Select Valve Series dialog where you can assign manufacturer-specific valves and VDI valves to the component. The range of valves depends on the installed manufacturer datasets. After assignment, the product data and parameters of the assigned valve are displayed.
Reset: The Reset button resets the manually assigned valve to a neutral model.
Info …: Available when valve data is selected. When using manufacturer-specific valves, opens the dialog Information about this Valve with further values and information stored in the data set. For custom valves, the Curve Data dialog opens with information on the custom data set.
Nominal Diameter
Shows the current nominal diameter of the valve of the system. You can select and set other dimensions from the drop-down list depending on the model. The determined nominal diameter is then used in the calculation.
locked
Enabled: The manually selected nominal diameter of the assigned valve is not adjusted during calculation.
Disabled: The nominal diameter of the assigned valve is adjusted based on the calculation results. The new assigned nominal diameter will be displayed the next time the dialog is opened.
Inlet, Outlet
Drop-down lists for selecting the connection types for the component's connections. This option is available only for manufacturer-neutral components. After selecting a connection, the selected connection type is also assigned to the other component connections. If necessary, you can also assign different connection types to the connections. The selected connections are included in the bill of materials. Based on the connection definition and the selected piping system, any required fittings will also be included in the bill of materials, provided that the data set for the selected piping system includes them.
kvs
Specifies the flow coefficient of the differential pressure transmitter when open.
Further Data
The current values for mass flow rate and pressure loss are displayed here.