Details on Select Duct Component
Information about the Select duct component dialog.
You are here:
Applies to: Ventilation.
Selection manufacturer and duct component type
Select the pipe duct component.
| Element | Description |
|---|---|
| Manufacturer | Drop-down list with manufacturers that provide models for the required duct component. |
| Duct component type | Select a duct component type. For some duct component types, it is possible to refine the selection with a duct component type. |
| Models/Name | After selecting the manufacturer and trunking component type, the available models are listed. Select a model to display the corresponding versions in the table. Clicking on the |
button opens a drop-down menu where you can sort the list of available models by Table of Version and Accessory Options
This table shows the different versions of the selected valve model. Some variants can be further narrowed down.
| Element | Meaning |
|---|---|
| Property | List of all available features for the selected valve model. |
| Name | For each property, the available variant of this property can be viewed under Name . For some properties, different variants are offered, which you can select using the |
button. Thevalves that correspond to the displayed variant and accessory options are listed in the table at the bottom of this dialog.Table of duct component designs
The column entries in the table vary depending on the selected duct component type.
| Element | Meaning |
|---|---|
| Selection | Enabled: The duct component with the selected nominal width can be used in the calculation. Disabled: Duct component with the selected nominal diameter will not be used for calculation. |
| Name | Shows the dimension of the selected component. |
| Order number | For manufacturer duct components, the manufacturer-specific order number of the component. |
| V(min)/V(max) | The component-specific smallest and largest volume flow in cubic meters per hour. |
VDI Import ...
This function is not available in the Ventilation discipline. Manufacturer data can be obtained via the LINEAR CAD Browser.
Reports ...
When selecting valves, the valve data is checked. This may result in warnings or errors. The button Reports... is colored red for errors and orange for notes. To ensure planning reliability in cases of errors, the data set will not be transferred and can not be used. If notes exist, they should be read in the report. Transfer is possible after reading the notes by clicking Apply. The note is not displayed again after the trunking component has been transferred to the preselection (Select duct component dialog).
Info...
Opens the dialog Information about this Valve, which displays various information about the currently selected valve, depending on the valve type.
The activated duct component will be checked simultaneously. If the check fails, faulty kinds can be deactivated ahead of transferring the selection.