Details on Component Data for Fittings
Information about the component data dialog for fittings.
A fitting may be any installed part within the network. It has two connection points, both of which are connected to another component.
You are here:
Name
Shows the name of the component. You cannot modify the name.
Calculation
For fittings, you may adjust the zeta value individually. This is then used to calculate the pressure loss at this component. If you calculate according to ÖVGW G11, the zeta value for all components is determined by the program and the field is deactivated.
Pin
Specifies whether multiple areas of the dialog can be opened simultaneously or whether only a single area can be opened.
Activated : Multiple areas of the dialog can be opened simultaneously.
Deactivated 
: Only one area of the dialog can be opened. When you open an area, other open areas of the dialog may be closed.