Jump directly to main navigation Jump directly to content

About Panel Heating in LINEAR Building

Here, you will find basic information about the setting up and functioning of the Panel heating module in LINEAR Building.

With the Panel heating module in LINEAR Building you can, based on the calculated heat load or on standard area values, design rooms, apartments, floors or building parts automatically and compliant with the standards for panel heating systems. You can adapt the design individually as required and optimize it subsequently.

A multitude of panel heating systems in manufacturers’ databases are available to you for the design process. In addition to floor heating systems, these also include ceiling and wall systems. If it is planned by the manufacturer, the layer composition of the individual system components can be modified. Depending on the system, control components can also be selected. Just as with the hydraulic topology (pipe runs, manifolds, manifold connections), you can adapt the default settings and system parameters of panel heating systems to the requirements of your project.

After the design process, the heating circuits can be marked and connected in your CAD program. The CAD model is then connected directly with the calculation in the panel heating/cooling system module. Actually occupied panels, feed pipe lengths and the hydraulic topology are adopted from the CAD model automatically. Other adaptations, such as the laying spacing, can be made both in CAD and in the building.

You can also start off designing in CAD and then begin calculation in the building. This is useful e.g. if the architecture is intended for optimal exploitation (complex feed pipe ducting or room geometries) and determines that a CAD model is to be created.

As a result, detailed material lists are created as well as extensive printouts are offered. In addition to ensuring the comprehensibility of the design, these documents also aid in the laying of the circuits and the setting of the valves on the construction site. In addition, you can create and print labels with all the necessary information for later labeling of manifolds and connections.