Details on "Pump Selection"

You are here:

Project Tab ➤ Discipline ➤ Analyse Tab ➤ Material Data ➤ Pumps …

or

Project tab ➤ Discipline ➤ Analyse tab ➤ Components ➤ Technical Data ... ➤ Pump Selection ➤ Catalog

Applies to: Heating, Cooling, Potable Water.

Select a manufacturer pump and assign its data to the pumps in the model if you have opened this dialog with the Pumps ...button in the Material Data area. Once you have opened the dialog from the Technical Data of a pump, click on Apply after selecting a pump to assign the data to the pump.

Manufacturer

All manufacturers whose data sets have been installed are available for selection here.

Series

Here all series are available, that are contained in the selected manufacturer data set.

Pump

Here, all models of the selected series are available.

Diagram

The graph shows the characteristics of the selected model.

Data Sheet

If the manufacturer provides a data sheet in the data set, you can view it here.

Apply

This button is only available if you have opened the dialog from the Technical Data of a pump and it assigns the manufacturer data of the selected model to this pump. This data is then used for calculation and in the bill of materials.

Reset <

Use this function to reset already assigned manufacturer data of a pump to neutral values. The delivery height and the flow rate of the pump are calculated and no manufacturer is given out.

Assign <

This function allows you to assign manufacturer data to a pump in the model, which is used for calculations and in parts lists.