Adding and Configuring a System for Preselection
Shows step-by-step how to add and configure radiant heating and cooling systems for system preselection.
Before you begin
You would like to add a radiant heating and cooling system for preselection, configure it according your project’s requirements and then design it.
Navigate to:
Applies to: Radiant Heating, Radiant Cooling
Procedure
- In the System Selection section, establish whether a floor, ceiling or wall system is to be added by selecting the corresponding button.
- Determine the Manufacturer, the System Group, the System and the Pipe to be used.
- Click
. The system is now in system preselection.
- Click System Parameters ... and adjust the system parameters to your project’s requirements.
- Click Screed Additive ... and add a screed additive.
- Adjust the default settings in the General Presettings section to your project’s requirements.
- Determine whether the design is to be Border zones always as independent circuits.
Results
You have added and configured the radiant heating and cooling systems for preselection.
What to do next
You can now design the system.