Jump directly to main navigation Jump directly to content

Detail on Assistant Fresh Water and Dwelling Stations

Information on the dialog Assistant Fresh water and dwelling stations.

With the assistant for fresh water and dwelling stations, you can dimension manufacturer models and insert it into the project. Furthermore, you can edit the configuration of stations that have already been drawn in. The prerequisite for using the assistant is the installation of a suitable manufacturer data set.

You are here:

AssistantsPotable water/Heating / Drawing typeSymbolsDwelling station ...

Applies to: Heating, Potable water.

Manufacturer, Product group, Product range

Select manufacturer, product group and version of the product. If you select a model including water meter calorimeter, the Calorimeter and Water meter sections are displayed.

Calorimeter, Water meter

Enter Nominal volume flow rate and Pressure loss for each of the meters if the product contains a heat quantity and water meter.

Selection Accessory material ...

Opens a dialog in which you can select accessory material that the manufacturer provides for this product. The accessory material is included in the parts lists.

Potable water ...

Opens the Requirement Potable water dialog, in which you can enter the potable water heating requirements for the dwelling station.

Floor heating ...

Opens the Requirement Floor heating dialog, in which you can enter the floor heating requirements for the dwelling station.

Product illustration

Shows a preview of the selected product. Some manufacturer offer a link to their homepage where you can get more information about the products.

Design capacity, Error messages, Notes

After successful dimensioning of the dwelling station the dimensioning data are displayed below the product illustration and the Draw < button is activated. If the selected product does not match the entered requirement for potable water heating and floor heating, an error message is displayed in red, below the product illustration and the dwelling station cannot be drawn. If the errors are corrected, the design data is displayed instead of the error message. Depending on the product, additional information texts are displayed below the design data or error message.

Technical data and Data sheet ...

If the manufacturer provides technical data and a data sheet in the data set, you can view these here.

Draw <

After clicking Draw < the dwelling station is attached to the mouse pointer and you can place it in the drawing with the settings you have made.

Get <

Clicking a dwelling station loads all data of this dwelling station including the relevant data of a possibly connected FH into the Assistant dialog.

Assign <

Transfers the data currently set in the dialog to all desired dwelling stations and connected FH. After selecting the desired dwelling stations in the drawing and confirming with the Enter key, a query can be used to select whether only the data is to be assigned or whether the model is also to be exchanged at the same time. When swapping models, the station is replaced from origin to origin.

If no symbol or 3D model is available for the dwelling station set in the dialog, only the new data will be written to the selected stations without a query.

If the current configuration of the dwelling station in the dialog is incorrect, the Assign < button is deactivated.