Details on “Siphonic Drainage” in the “Settings” (Wastewater/Roof Drainage)
Information about the Material tab in the Settings dialog of the Pipe Network Calculation Waste Water and Roof Drainage.
You are here:
Tolerance between two bends or branch/bend
Minimum pipe length from which a pipe section is included in the parts list. If a pipe between bends or branches is shorter than the set minimum length, the pipe section is not listed in the parts list. The proposed length of 141mm corresponds to the drawn standard chamfer of 100mm.
Distance between roof drain and bend
Maximum distance for connection bends with short construction type. If the distance between the roof outlet and the bend is smaller than specified, a short type connecting bend is included in the parts list, if it is available with the selected pipe system.
Layer for fixing material
Opens the dialog Select Layer - <...>, where you can specify the layer on which the mounting material should be drawn. This creates a connection between drawn fixing and the material. By default, the mounting material is drawn on the layer S___DRAW_FIX.
Reducing pieces eccentric
Enabled: Reducing parts for all siphonic pipe pipe sections are issued eccentrically.
Disabled: Reducing parts for all siphonic pipe pipe sections are issued concentrically.
You can also set this option separately for each siphonic pipe section using the edit functions in the calculation dialog.
Radius to remove guide brackets next to anchor points
When mounting pipes, you can determine the radius within which superfluous slide bearings near fixed bearings are removed.