Details on Pipe Section Data
Information about the dialog Pipe section data.
You are here:
Applies to Heating, Potable water, Waste water and Gas.
Section
Length
Sets the length of the pipe section selected in the scheme. The value is applied to both the supply and return pipes. The length is then displayed in the scheme above the pipe section. The actual length of the pipe section is determined from the finished scheme and also depends on the pipe routing. The lengths are not drawn, but only stored as a value in the pipe section or component.
Additional bends
Sets the number of additional bends of the pipe section. The number of additional bends is then displayed in the scheme above the pipe section. Additional bends are output in the parts list after the calculation has been completed.
Pipe material
from project settings
Enabled: The material specified in the project settings is used for the pipe section.
Disabled: You can assign a material to the pipe section that differs from the project setting. Use the Material button now activated to open the Pipe tables dialog to define a desired material.
Pipe nominal diameter
If a pipe material is assigned, you can set nominal diameters for the pipes of the section parts here.
Dimensions listed with an asterisk in the drop-down list have been disabled in the Pipe tables. If special dimensions are to be used specifically, the deactivated dimensions are also available for selection here.
Pipe type
This section is available only for waste water pipe sections and defines the pipe type of the pipe section.
Navigation buttons
, 
, 
Use the and buttons to switch horizontally between the pipe sections of the scheme. The active pipe section is shown dashed in the scheme.
With the button you can switch to the vertically running feed pipes. The active pipe section is shown dashed in the scheme.