Configuring Correction Factors
Shows step-by-step how to set the Beta 1 and Beta 2 correction factors project wide.
Before you begin
You would like to multiply the calculated standard heat load project-wide by the correction factors β1 and β2 to take into account the conditions of your project.
Navigate to:
Note:
Both correction factors can also be specifically entered at room level if required.
Procedure
- Click
next to β1. The Factor for additional heat loss of heating devices acc. to contruction type dialog opens.
- Select a suitable entry from the list and confirm your selection with OK.
- Enter the desired value for β2.
You can enter a number between 1 and 2.
Results
The correction factors are entered and multiplied by the standard heat load. The result display shows the additional loads due to the correction factors.