Adjusting Labels in the Pipe and Duct Network Calculation
Shows step-by-step how to adjust the labels for a calculated pipe or duct network using the Configure Labels section of the Labels dialog.
Before you begin
After calculating your pipe or duct network, you would like to label the components with the calculation and component data and customize the labels for this purpose.
Requirement:
You have successfully performed the Pipe and Duct Network Calculation.
Navigate to
Procedure
- In the calculation dialog menu, click Labeling....
- In the Configure label section, locate the line containing the network object for which you would like to customize the label.
- Click the button
in the Label left or Label right column and select the <create automatically> entry in the drop-down list. 
- Click the
button to open the Configure Labeling Parameters dialog. - In the first column, check the boxes for the data types that should be output in the label. Note: With one click in the column header you can set all check marks at once. Another click removes all check marks and a third click restores the default setting.
- Select further settings for the label, for example the unit, the number of decimal places or the color.
- Close the dialog with OK.
Results
You have adjusted the labeler for the selected network object. If you now start the labeling function, the customized label will be used.
Note: If necessary, make the same settings for the relevant network object in the Label left or Label right column.